What other names or designations is the Autogenous / semi-autogenous mill known by?
The Autogenous / semi-autogenous mill is also documented under these designations: Fuller-Traylor SAG / AG mills, SAG 8.0×3.2m.
Autogenous / semi-autogenous mill
AG / SAG mill · 1 model
Fuller Traylor
Fuller TraylorBrand
AG / SAG millEquipment type
Historical modelStatus
Fuller Traylor
Models and Historical Names in This Series
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Components |
|---|---|---|
| Fuller-Traylor SAG / AG mills | SAG 8.0×3.2m | 8 |
Fuller Traylor
Numbered Components
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Main bearing | Blue bearing support beneath right trunnion | FLS SAG mill (current OEM gear-drive rendering configuration; dimensions not specified) |
| 2 | Girth gear | Visible girth gear teeth inside yellow guard at top | FLS SAG mill (current OEM gear-drive rendering configuration; dimensions not specified) |
| 3 | Mill shell | Blue mill shell on left side of unit | FLS SAG mill (current OEM gear-drive rendering configuration; dimensions not specified) |
| 4 | Feed chute | Grey feed chute at right end | FLS SAG mill (current OEM gear-drive rendering configuration; dimensions not specified) |
| 5 | Girth gear guard | Yellow guard above girth gear | FLS SAG mill (current OEM gear-drive rendering configuration; dimensions not specified) |
Other Components · 6 items
| Component |
|---|
| Ring gear and pinion drive |
| Discharge drum screen |
| Mill lining |
| Low speed synchronous motor |
| Pneumatic clutch |
| Single transmission pinion |
Fuller Traylor
Components by Model
Models with the same components are grouped together; select a group to open its component table.
Fuller-Traylor SAG / AG mills8 items
| No. | Component | Location |
|---|---|---|
| 1 | Main bearing | Cylinder or hollow shaft support |
| 2 | Transmission ring gear | Hartley grinding shell drive side |
| Ring gear and pinion drive | Geared transmission configuration | |
| Discharge drum screen | Optional screening component at discharge end | |
| Mill lining | Inside the cylinder | |
| Low speed synchronous motor | Hartley Mill Drive | |
| Pneumatic clutch | Between Hartley motor and gear drive | |
| Single transmission pinion | Hartley mill drive ring gear side |
Frequently asked questions
Which brand and type of equipment is the Autogenous / semi-autogenous mill?
The Autogenous / semi-autogenous mill is listed under the Fuller Traylor brand as: AG / SAG mill. Status: Historical model.
Which components and wear parts are recorded for the Autogenous / semi-autogenous mill?
8 components are recorded, including: Main bearing, Ring gear and pinion drive, Discharge drum screen, Mill lining, Low speed synchronous motor, Pneumatic clutch, Single transmission pinion, Transmission ring gear. The full list with locations is in the components table on this page.
How do I enquire about parts for the Autogenous / semi-autogenous mill?
Send us a drawing or sample and tell us the equipment model and part name.