What other names or designations is the Fuller-Traylor SAG / AG mills known by?
The Fuller-Traylor SAG / AG mills is also documented under these designations: SAG 8.0×3.2m.
AG / SAG mill · 1 model


Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Components |
|---|---|---|
| Fuller-Traylor SAG / AG mills | SAG 8.0×3.2m | 8 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Main bearing | Blue bearing support beneath right trunnion | FLS SAG mill |
| 2 | Girth gear | Visible girth gear teeth inside yellow guard at top | FLS SAG mill |
| 3 | Mill shell | Blue mill shell on left side of unit | FLS SAG mill |
| 4 | Feed chute | Grey feed chute at right end | FLS SAG mill |
| 5 | Girth gear guard | Yellow guard above girth gear | FLS SAG mill |
| Component |
|---|
| Ring gear and pinion drive |
| Discharge drum screen |
| Mill lining |
| Low speed synchronous motor |
| Pneumatic clutch |
| Single transmission pinion |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component | Location |
|---|---|---|
| 1 | Main bearing | Cylinder or hollow shaft support |
| 2 | Transmission ring gear | Hartley grinding shell drive side |
| Ring gear and pinion drive | Geared transmission configuration | |
| Discharge drum screen | Optional screening component at discharge end | |
| Mill lining | Inside the cylinder | |
| Low speed synchronous motor | Hartley Mill Drive | |
| Pneumatic clutch | Between Hartley motor and gear drive | |
| Single transmission pinion | Hartley mill drive ring gear side |
The Fuller-Traylor SAG / AG mills is also documented under these designations: SAG 8.0×3.2m.
The Fuller-Traylor SAG / AG mills is listed under the Fuller Traylor brand as: AG / SAG mill. Status: Historical model.
8 components are recorded, including: Main bearing, Ring gear and pinion drive, Discharge drum screen, Mill lining, Low speed synchronous motor, Pneumatic clutch, Single transmission pinion, Transmission ring gear. The full list with locations is in the components table on this page.
Envoyez-nous un plan ou un échantillon et indiquez le modèle d'équipement et le nom de la pièce.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Ou contactez-nous directement : +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to drawing, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
Veuillez fournir la marque de l’équipement, le modèle complet et le numéro de série, le nom de la pièce, sa référence ou le numéro du plan, l’indice de révision du plan, la quantité, les exigences relatives au matériau et les conditions de service. Si ces identifiants ne sont pas disponibles, envoyez des photographies et les dimensions principales.
Submit an Enquiry