Cone crusher · 4 models
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Components |
|---|---|---|
| Pegson Autosand 1000 | 1000 Autosand | 4 |
| Pegson Autosand 1300 | 1300 Autosand | 4 |
| Pegson Autosand 1500 | 1500 Autosand | 4 |
| Pegson Autosand 900 | Autosand 900 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Hydraulic cylinders | Vertical adjustment and overload protection cylinder outside the upper frame | Automax / Autosand OEM shared-photo representative unit (exact model and chamber not specified) |
| 2 | Drive pulley | Green drive pulley at the right rear of the crusher | Automax / Autosand OEM shared-photo representative unit (exact model and chamber not specified) |
| 3 | Lubrication assembly | Separate oil tank and pump assembly on the right | Automax / Autosand OEM shared-photo representative unit (exact model and chamber not specified) |
| Component |
|---|
| Mantle |
| Bowl liner / concave |
| Eccentric sleeve |
| Countershaft |
Models with the same components are grouped together; select a group to open its component table.
Models: Pegson Autosand 1000, Pegson Autosand 1300, Pegson Autosand 1500
| Component |
|---|
| Mantle |
| Concave |
| Eccentric sleeve |
| Drive shaft |
The Autosand Cone crusher covers 4 models: Pegson Autosand 1000, Pegson Autosand 1300, Pegson Autosand 1500, Pegson Autosand 900. Former and renamed designations are listed in the models table on this page.
The Autosand Cone crusher is also documented under these designations: Pegson Autosand 1000, 1000 Autosand, Pegson Autosand 1300, 1300 Autosand, Pegson Autosand 1500, 1500 Autosand, Pegson Autosand 900, Autosand 900.
The Autosand Cone crusher is listed under the Pegson brand as: Cone crusher. Status: Historical model.
4 components are recorded, including: Mantle, Concave, Eccentric sleeve, Drive shaft. The full list with locations is in the components table on this page.
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry