Cone crusher · 4 models
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Components |
|---|---|---|
| Pegson Automax 1000 | 1000 Automax | 4 |
| Pegson Automax 1300 | 1300 Automax | 4 |
| Pegson Automax 1500 | 1500 Automax | 4 |
| Pegson Automax 900 | Automax 900 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Hydraulic cylinders | Vertical adjustment and overload protection cylinder outside the upper frame | Automax / Autosand |
| 2 | Drive pulley | Green drive pulley at the right rear of the crusher | Automax / Autosand |
| 3 | Lubrication assembly | Separate oil tank and pump assembly on the right | Automax / Autosand |
| Component |
|---|
| Mantle |
| Bowl liner / concave |
| Eccentric sleeve |
| Countershaft |
Models with the same components are grouped together; select a group to open its component table.
Models: Pegson Automax 1000, Pegson Automax 1300, Pegson Automax 1500
| Component |
|---|
| Mantle |
| Concave |
| Eccentric sleeve |
| Drive shaft |
The Automax Cone crusher covers 4 models: Pegson Automax 1000, Pegson Automax 1300, Pegson Automax 1500, Pegson Automax 900. Former and renamed designations are listed in the models table on this page.
The Automax Cone crusher is also documented under these designations: Pegson Automax 1000, 1000 Automax, Pegson Automax 1300, 1300 Automax, Pegson Automax 1500, 1500 Automax, Pegson Automax 900, Automax 900.
The Automax Cone crusher is listed under the Pegson brand as: Cone crusher. Status: Historical model.
4 components are recorded, including: Mantle, Concave, Eccentric sleeve, Drive shaft. The full list with locations is in the components table on this page.
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the equipment brand, complete model and serial number, part name, part number or drawing number, drawing revision, quantity, material requirements and duty. If identifiers are unavailable, send photographs and key dimensions.
Submit an Enquiry