2012 · 1 model
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Jeffrey Rader | Pneumatic Conveying; Mark III Flat Back Elbow; Model E Cyclone; Belt / Direct Drive Blower Assembly | 2012 | 6 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Cyclone barrel | Upper cylindrical separation chamber | Model E Cyclone |
| 1 | Elbow wear back | Bolted wear back on the outside of the bend | Mark III Flat Back Elbow |
| 2 | Cyclone cone | Conical discharge section beneath the barrel | Model E Cyclone |
| 3 | Inlet connection | Inlet connection on the front-left of the barrel | Model E Cyclone |
| Component |
|---|
| Cyclone barrel liner |
| Cyclone cone liner |
| Inlet wear section |
| Blower assembly |
| Rotary airlock feeder |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component |
|---|---|
| 1 | Model-specific component |
| Model-specific component | |
| Model-specific component | |
| Model-specific component | |
| Blower assembly | |
| Model-specific component |
The Pneumatic Conveying system is also documented under these designations: Jeffrey Rader, Pneumatic Conveying, Mark III Flat Back Elbow, Model E Cyclone, Belt / Direct Drive Blower Assembly.
The Pneumatic Conveying system is listed under the TerraSource Global brand. Period: 2012. Status: Historical model.
6 components are recorded, including: Blower assembly and more. The full list with locations is in the components table on this page.
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry