Equipment Series
Metso Cone Crushers
METSO · Part Details
Cone crusher chamber liner system
Cone Crusher Crushing Chamber Liner System
Identify parts for Metso cone crushers, check models and drawing, confirm materials and processes, and submit an inquiry.
Equipment and Applicable Models
Identify the installed machine model and key dimensions, then check the drawing revision and physical interfaces.
Models and Key Dimensions
Metso HP series (HP100-HP800), GP series (GP100-GP550), and MP series (MP800-MP1000)
Materials and Processes
Select the material grade and heat treatment for the operating conditions, processed material and equipment specifications. The options below are commonly used; confirm the final grade against the drawing and technical agreement.
High-Manganese Steel Mn18Cr2
Material option for standard chamber liners, with work-hardening capability after solution treatment and water quenching
Metso XT710
Specify independently manufactured replacement materials through the agreed specification, heat certificate and test results. Where an OEM commercial material is cited for identification, label it as an original-part reference and confirm ANRANST supply material separately without assuming equivalence or a life multiplier.
Metso MX composite wear material
A manganese steel matrix with wear-resistant inserts. Metso states that its MX for cones products can achieve up to 2 times the wear life of standard manganese liners under suitable conditions. This is not a service-life guarantee for parts supplied through this website.
Wear Characteristics and Replacement
Common wear modes and maintenance advice. The actual replacement interval depends on duty, material and operating data.
Common wear modes
- The parallel liner zone typically wears fastest, affecting product size
- The feed zone wears more slowly, but its condition affects material distribution and throughput
- Distortion of the liner profile through wear reduces crushing efficiency and increases power consumption
Replacement criteria
Inspect wear, cracking, fits, lubrication and fastening to the specific maintenance manual, part drawing and approved site plan. Cite model-specific documents for change-out limits and assembly settings; generic website percentages must not replace responsible site assessment.
Material and Process Control
Materials, heat treatment, composite processes and inspection follow the specific drawing, duty and technical review.
Material Grade / Substrate
High-manganese steel Mn18Cr2, Metso XT710 and Metso MX composite materials
Heat Treatment Condition
Solution heat treatment with water quenching. Final hardness and microstructure must meet the drawing and agreed technical specification.
Composite / Hardfacing Requirements
Metso MX composite liners use a manganese steel matrix with wear-resistant inserts rather than hardfacing. Replace the complete liner; localized repair is not applicable.
Dimensions and Inspection
Manufacture to drawings produced from part measurements or supplied by the customer. Critical mating surface tolerances follow OEM requirements. Use UT/MT inspection to assess castings for shrinkage porosity and cracks against the agreed acceptance criteria.
Parts with the same name may not be interchangeable across models, drawing revisions, interfaces and materials. Confirm the full model, serial number and drawings before manufacture.