What other names or designations is the SALA Wet Low-Intensity Magnetic Separators known by?
The SALA Wet Low-Intensity Magnetic Separators is also documented under these designations: Sala.
SALA Wet Low-Intensity Magnetic Separators
1 model
Sala
SalaBrand
Historical modelStatus
Sala
Models and Historical Names in This Series
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Components |
|---|---|
| Sala | 4 |
Current successor model: Metso
Sala
Numbered Components
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Magnetic separator assembly | Whole separator shown in the patent figure | EP0520971A1 illustrated embodiment |
| 2 | Magnetic drum | Circular drum perimeter in the patent figure | EP0520971A1 illustrated embodiment |
| 3 | Drum axle | Cross at the center of the drum section | EP0520971A1 illustrated embodiment |
| 4 | Stationary magnet system | Magnets arranged inside the drum circumference | EP0520971A1 illustrated embodiment |
| 5 | Magnetic yoke | Grouped support region of the internal magnets | EP0520971A1 illustrated embodiment |
| 6 | Slurry tank | Slurry passage outside the lower drum | EP0520971A1 illustrated embodiment |
| 7 | Water delivery device | Wash-water inlet near the concentrate outlet | EP0520971A1 illustrated embodiment |
| 8 | Concentrate outlet | Magnetic product outlet at the right of the figure | EP0520971A1 illustrated embodiment |
| 9 | Tailings outlet | Non-magnetic product outlets at the bottom and left | EP0520971A1 illustrated embodiment |
| 10 | Baffle rib | Tank bottom beside the lower tailings outlet | EP0520971A1 illustrated embodiment |
| 11 | Control valve | Below the bottom tailings outlet | EP0520971A1 illustrated embodiment |
| 12 | Feeder | Feed passage above the drum | EP0520971A1 illustrated embodiment |
Sala
Components by Model
Models with the same components are grouped together; select a group to open its component table.
Sala4 items
| No. | Component |
|---|---|
| 2 | Model-specific component |
| 4 | Model-specific component |
| 6 | Pulp trough |
| 8 | Model-specific component |
Frequently asked questions
Which brand and type of equipment is the SALA Wet Low-Intensity Magnetic Separators?
The SALA Wet Low-Intensity Magnetic Separators is listed under the Sala brand. Status: Historical model.
Which components and wear parts are recorded for the SALA Wet Low-Intensity Magnetic Separators?
4 components are recorded, including: Pulp trough and more. The full list with locations is in the components table on this page.
What is the current successor of the SALA Wet Low-Intensity Magnetic Separators?
Metso.
How do I enquire about parts for the SALA Wet Low-Intensity Magnetic Separators?
Send us a drawing or sample and tell us the equipment model and part name.