Which brand and type of equipment is the Sala?
The Sala is listed under the Sala brand. Status: Historical model.
1 model


Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Components |
|---|---|
| Sala | 4 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Magnetic separator assembly | Whole separator shown in the patent figure | EP0520971A1 illustrated embodiment |
| 2 | Magnetic drum | Circular drum perimeter in the patent figure | EP0520971A1 illustrated embodiment |
| 3 | Drum axle | Cross at the center of the drum section | EP0520971A1 illustrated embodiment |
| 4 | Stationary magnet system | Magnets arranged inside the drum circumference | EP0520971A1 illustrated embodiment |
| 5 | Magnetic yoke | Grouped support region of the internal magnets | EP0520971A1 illustrated embodiment |
| 6 | Slurry tank | Slurry passage outside the lower drum | EP0520971A1 illustrated embodiment |
| 7 | Water delivery device | Wash-water inlet near the concentrate outlet | EP0520971A1 illustrated embodiment |
| 8 | Concentrate outlet | Magnetic product outlet at the right of the figure | EP0520971A1 illustrated embodiment |
| 9 | Tailings outlet | Non-magnetic product outlets at the bottom and left | EP0520971A1 illustrated embodiment |
| 10 | Baffle rib | Tank bottom beside the lower tailings outlet | EP0520971A1 illustrated embodiment |
| 11 | Control valve | Below the bottom tailings outlet | EP0520971A1 illustrated embodiment |
| 12 | Feeder | Feed passage above the drum | EP0520971A1 illustrated embodiment |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component |
|---|---|
| 2 | Model-specific component |
| 4 | Model-specific component |
| 6 | Pulp trough |
| 8 | Model-specific component |
The Sala is listed under the Sala brand. Status: Historical model.
4 components are recorded, including: Pulp trough and more. The full list with locations is in the components table on this page.
Metso.
Envoyez-nous un plan ou un échantillon et indiquez le modèle d'équipement et le nom de la pièce.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Ou contactez-nous directement : +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to drawing, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
Veuillez fournir la marque de l’équipement, le modèle complet et le numéro de série, le nom de la pièce, sa référence ou le numéro du plan, l’indice de révision du plan, la quantité, les exigences relatives au matériau et les conditions de service. Si ces identifiants ne sont pas disponibles, envoyez des photographies et les dimensions principales.
Submit an Enquiry