Equipment Series
Metso Sand Making Machine
METSO · Part Details
Rotor Top Wear Plate
Top External Wear Plate
Identify parts for Metso sand making machines, check models and drawing, confirm materials and processes, and submit an inquiry.
Equipment and Applicable Models
Identify the installed machine model and key dimensions, then check the drawing revision and physical interfaces.
Models and Key Dimensions
Metso VSI Impact Crusher Range
Materials and Processes
Select the material grade and heat treatment for the operating conditions, processed material and equipment specifications. The options below are commonly used; confirm the final grade against the drawing and technical agreement.
Wear-Resistant Steel at 400–500 HBW
Select materials to suit OEM specifications and operating conditions; confirm the final grade and heat treatment against the drawing.
Hardened Wear Lip
Select materials to suit OEM specifications and operating conditions; confirm the final grade and heat treatment against the drawing.
Wear Characteristics and Replacement
Common wear modes and maintenance advice. The actual replacement interval depends on duty, material and operating data.
Common wear modes
- Material impact causes surface wear and deformation
- Sliding material causes grooving wear
- Localized impact causes dents
- Wear affects equipment operating efficiency
Replacement criteria
Assess replacement against the remaining-thickness limits in the equipment manual and drawings. Inspect and take corrective action if through-cracks occur or equipment performance is affected.
Material and Process Control
Materials, heat treatment, composite processes and inspection follow the specific drawing, duty and technical review.
Material Grade / Substrate
Wear-Resistant Steel at 400–500 HBW / Hardened Wear Lip
Heat Treatment Condition
Follow the applicable standard for the material grade; confirm heat treatment and hardness requirements against the drawing
Composite / Hardfacing Requirements
Follow OEM design requirements; confirm any hardfacing or composite construction against the drawing
Dimensions and Inspection
Inspect key dimensions against the drawing for the OEM model details. Check mounting and sealing surfaces individually and perform UT/MT non-destructive testing on castings.
Parts with the same name may not be interchangeable across models, drawing revisions, interfaces and materials. Confirm the full model, serial number and drawings before manufacture.