Rotor Tip
Rotor Tip Set
METSO · Part Details
Sand Making Machine Rotor Wear System
VSI Rotor Wear System
Identify parts for Metso sand making machines, check models and drawing numbers, confirm materials and processes, and submit an inquiry.
Key Parts Covered
This page identifies installation positions that share the same wear-resistant material and manufacturing process requirements.
Backup Rotor Tip
Back-up Tip
Port Cavity Wear Plate
Tip / Cavity Wear Plate
Upper Internal Rotor Wear Plate
Upper Internal Wear Plate
Lower Internal Rotor Wear Plate
Lower Internal Wear Plate
Distributor Plate
Distributor Plate
Trail Plate
Trail Plate
Feed Pipe
Feed Tube
Feed Eye Ring
Feed Eye Ring
Rotor Top Wear Plate
Top External Wear Plate
Rotor Bottom Wear Plate
Bottom External Wear Plate
Wear Part Retaining Strip
Retaining Bar
Open Rotor Throwing Shoe
Open-table Shoe / Impeller
Materials and Processes
Select the material grade and heat treatment for the operating conditions, processed material and equipment specifications. The options below are commonly used; confirm the final grade against the drawing and technical agreement.
Confirm against the OEM specification
Select materials to suit OEM specifications and operating conditions; confirm the final grade and heat treatment against the drawing.
Wear and Replacement Criteria
Common wear patterns and maintenance guidance are outlined below. Determine replacement intervals from operating conditions, processed material and equipment performance data.
Common Wear Patterns
- Normal wear reduces performance
- Impact and vibration loosen fasteners
- Wear affects equipment operating efficiency
Replacement Criteria
Inspect regularly according to the equipment maintenance manual and replace when wear affects performance.
Equipment, Models and Drawing References
Identify the installed machine model and key dimensions, then check the part number, drawing number, drawing revision and physical interfaces.
Equipment Series
Metso Sand Making Machine
Models and Key Dimensions
Metso VSI Impact Crusher Range
Drawing Number / Part Number
Send the nameplate model, existing part number and drawings to identify the required spare part.
Drawing Revision
Confirm dimensions by measuring the sample or using the customer drawing. Cross-check the drawing revision against the model on the equipment nameplate.
Materials and Processes
Materials, heat treatment, composite construction and inspection requirements depend on the specific drawing, operating conditions and technical review.
Material Grade / Substrate
Confirm against the OEM specification
Heat Treatment Condition
Follow the applicable standard for the material grade; confirm heat treatment and hardness requirements against the drawing
Composite / Hardfacing Requirements
Follow OEM design requirements; confirm any hardfacing or composite construction against the drawing
Dimensions and Inspection
Inspect key dimensions against the drawing for the OEM part number. Check mounting and sealing surfaces individually and perform UT/MT non-destructive testing on castings.
Parts with the same name may not be interchangeable because of differences in machine model, drawing revision, mounting interface or material specification. Use the complete model, serial number, drawing number and drawing before manufacture.