Equipment Series
Metso Impact Crusher
METSO · Part Details
Rotor Bearing
Rotor Bearing
Identify parts for Metso impact crushers, check models and drawing numbers, confirm materials and processes, and submit an inquiry.
Equipment, Models and Drawing References
Identify the installed machine model and key dimensions, then check the part number, drawing number, drawing revision and physical interfaces.
Models and Key Dimensions
Metso Nordberg NP Series Range
Drawing Number / Part Number
Provide the equipment nameplate, complete model and existing part number so that the installation position and drawings can be checked.
Drawing Revision
Confirm dimensions by measuring the sample or using the customer drawing. Cross-check the drawing revision against the model on the equipment nameplate.
Materials and Processes
Select the material grade and heat treatment for the operating conditions, processed material and equipment specifications. The options below are commonly used; confirm the final grade against the drawing and technical agreement.
Bearing Steel 100Cr6
Select materials to suit OEM specifications and operating conditions; confirm the final grade and heat treatment against the drawing.
SAE 52100 (HRC 60-64)
Select materials to suit OEM specifications and operating conditions; confirm the final grade and heat treatment against the drawing.
Wear and Replacement Criteria
Common wear patterns and maintenance guidance are outlined below. Determine replacement intervals from operating conditions, processed material and equipment performance data.
Common Wear Patterns
- Contact fatigue spalling of rolling elements and raceways
- Cage wear
- Inadequate lubrication causes overheating and wear
- Contamination causes abrasive wear
Replacement Criteria
Inspect if abnormal vibration or noise occurs. Replace when clearance exceeds the design value, or immediately if fatigue spalling occurs. Schedule preventive replacement according to the design service life.
Materials and Processes
Materials, heat treatment, composite construction and inspection requirements depend on the specific drawing, operating conditions and technical review.
Material Grade / Substrate
Bearing Steel 100Cr6 / SAE 52100 (HRC 60-64)
Heat Treatment Condition
Follow the applicable standard for the material grade; confirm heat treatment and hardness requirements against the drawing
Composite / Hardfacing Requirements
Follow OEM design requirements; confirm any hardfacing or composite construction against the drawing
Dimensions and Inspection
Inspect key dimensions against the drawing for the OEM part number. Check mounting and sealing surfaces individually and perform UT/MT non-destructive testing on castings.
Parts with the same name may not be interchangeable because of differences in machine model, drawing revision, mounting interface or material specification. Use the complete model, serial number, drawing number and drawing before manufacture.