Which models does the PR Mining cover?
The PR Mining covers 4 models: PR 756, PR 766, PR 776 G8, PR. Former and renamed designations are listed in the models table on this page.
PR Mining
2024 —2026 · 4 models
Liebherr
LiebherrBrand
2024 —2026Period
Historical modelStatus
Liebherr
Models and Historical Names in This Series
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
Liebherr
Numbered Components
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Blade cutting edge | Lower cutting edge of blade | PR 776 G8 |
| 2 | Ripper tooth | Tip of rear ripper shank | PR 776 G8 |
| 3 | Track shoes | Lower ground-contact track run | PR 776 G8 |
Liebherr
Components by Model
Models with the same components are grouped together; select a group to open its component table.
PR 756, PR 766, PR 776 G84 items
Models: PR 756, PR 766, PR 776 G8
| No. | Component | Location |
|---|---|---|
| 1 | Blade cutting edge | Bottom edge of the dozer blade |
| 2 | Ripper tooth | Tip of the rear ripper shank |
| 3 | Track shoe | Ground-contact working surface of the track |
| Blade end bit | Left and right corners of the dozer blade |
PR2 items
| No. | Component | Location |
|---|---|---|
| 1 | Blade cutting edge | Bottom edge of the dozer blade |
| 2 | Ripper tooth | Tip of the rear ripper shank |
Frequently asked questions
What other names or designations is the PR Mining known by?
The PR Mining is also documented under these designations: PR 756, PR 766, PR 776 G8, PR, PR 716, PR 726, PR 736, PR 746, PR 716 Litronic, PR 726 Litronic, PR 746 Litronic.
Which brand and type of equipment is the PR Mining?
The PR Mining is listed under the Liebherr brand. Period: 2024 —2026. Status: Historical model.
Which components and wear parts are recorded for the PR Mining?
4 components are recorded, including: Blade cutting edge, Blade end bit, Ripper tooth, Track shoe. The full list with locations is in the components table on this page.
Which model-specific components of the PR Mining have their own page?
Model-specific components with their own page: Blade cutting edge, Blade end bit, Ripper tooth, Track shoe (4 in total).
How do I enquire about parts for the PR Mining?
Send us a drawing or sample and tell us the equipment model and part name.