2024 —2026 · 1 model
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| A | A 909 Compact; A 910 Compact; A 912 Compact; A 913 Compact; A 914 Compact; A 916 Compact; A 918 Compact; A 914 Litronic; A 916 Litronic; A 918 Litronic; A 920 Litronic; A 924 Litronic; A 924; A 922; A 911 Compact | 2024 —2026 | 5 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Pins and bushes | Attachment pivot at stick end | A 918 G8 |
| 2 | Clamshell grab | Working attachment at stick end | A 918 G8 |
| 3 | Hydraulic cylinder | Cylinder along the stick | A 918 G8 |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component | Location |
|---|---|---|
| 1 | Pin shaft and shaft sleeve | All pivot points of the boom, arm and bucket |
| Bucket tooth | In front of the bucket cutting edge | |
| Tooth adapter | Connection between the bucket lip and bucket teeth | |
| Bucket lip | Cutting area at the front edge of the bucket | |
| Side protector | Left and right side edges of the bucket |
The Wheeled excavator is also documented under these designations: A, A 909 Compact, A 910 Compact, A 912 Compact, A 913 Compact, A 914 Compact, A 916 Compact, A 918 Compact, A 914 Litronic, A 916 Litronic, A 918 Litronic, A 920 Litronic, A 924 Litronic, A 924.
The Wheeled excavator is listed under the Liebherr brand. Period: 2024 —2026. Status: Historical model.
5 components are recorded, including: Bucket tooth, Tooth adapter, Bucket lip, Side protector, Pin shaft and shaft sleeve. The full list with locations is in the components table on this page.
Model-specific components with their own page: Bucket tooth, Tooth adapter, Bucket lip, Side protector, Pin shaft and shaft sleeve (5 in total).
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry