01
Vertimill VTM المعدات والأجزاء
Models, wear parts, spares and tooling
Explore the model table, liner numbers, wear parts, mechanical spares, material options, maintenance tools and quotation options.
Explore Vertimill VTM →
Legacy Installation Identification
Find Parts for الطرازات القديمة
Use this page to identify a legacy Vertimill installation, then follow the Vertimill VTM equipment link for wear parts, mechanical spares, materials, part numbers and maintenance tooling.
VTM-15-WB First Listed Model
VTM-4500-C Last Listed Model
W / WB / LS / C Model Suffixes to Check
1 المعدات والأجزاء
Installation Identification
Legacy VTM Model Groups
The model narrows the identification process. Manufacturing and quotation also require the full suffix, serial number, liner generation, part number, drawing revision and measured dimensions.
| Identification Group | Listed Models | Identification priorities |
|---|---|---|
| Small and Early WB التركيبات | VTM-15-WB, 20-WB, 30-WB, 100-WB, 125-WB, 250-WB, 300-WB, 500-WB | Nameplate, full suffix, serial number, screw and liner generation |
| Medium and Large WB التركيبات | VTM-650-WB, 800-WB, 1000-WB, 1250-WB, 1500-WB, 2250-WB, 3000-WB | Power designation, assembly version, liner segmentation, drawing number and interface dimensions |
| C and Other Legacy Suffixes | VTM-3750-C and VTM-4500-C; identify W, LS and other legacy suffixes from the nameplate | Full model, wet or dry configuration, installation records and drawing revision |
Parts Directory
Vertimill Parts for Legacy and Current التركيبات
Identify the installation first, then check screw wear liners, end liners, wear caps, shaft protection, Orebed magnetic liners, drive spares and dedicated maintenance tools.
Can the VTM number alone identify a part?
No. Also check the full suffix, serial number, liner generation, installation position, part number and drawing revision.
Where can I find parts for a legacy installation?
Open the Vertimill VTM equipment page to explore wear parts, mechanical spares, identified part numbers and material options.
What should I provide if I do not have a drawing number?
Provide the nameplate, full model, serial number, photographs of the existing part, installation position, critical dimensions, current material and operating conditions.