What other names or designations is the Grinding known by?
The Grinding is also documented under these designations: Outokumpu, AG, Trunnion-supported, Shell-supported.
Grinding
2006 · 1 model
Outokumpu
OutokumpuBrand
2006Period
Historical modelStatus
Outokumpu
Models and Historical Names in This Series
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Outokumpu | AG; Trunnion-supported; Shell-supported | 2006 | 6 |
Outokumpu
Numbered Components
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Shell liner | Inside the cut-open shell | Trunnion-supported |
| 2 | Trunnion bearing | Inside the bearing housing at the feed trunnion | Trunnion-supported |
| 3 | Ring gear | Around the shell at the feed end, inside the guard | Trunnion-supported |
| 4 | Feed chute | At the feed-end trunnion inlet | Trunnion-supported |
| 5 | Mill shell | Central rotating shell | Trunnion-supported |
| 6 | Mill head | Between the feed bearing and shell | Trunnion-supported |
Other Components · 2 items
| Component |
|---|
| Lifter bar |
| Pinion |
Outokumpu
Components by Model
Models with the same components are grouped together; select a group to open its component table.
Outokumpu6 items
| No. | Component |
|---|---|
| 1 | Shell liner |
| 2 | Hollow trunnion Bearing |
| 3 | Ring gear |
| 4 | Feed chute |
| Lifter bar | |
| Pinion |
Frequently asked questions
Which brand and type of equipment is the Grinding?
The Grinding is listed under the Outokumpu brand. Period: 2006. Status: Historical model.
Which components and wear parts are recorded for the Grinding?
6 components are recorded, including: Shell liner, Lifter bar, Hollow trunnion Bearing, Ring gear, Pinion, Feed chute. The full list with locations is in the components table on this page.
How do I enquire about parts for the Grinding?
Send us a drawing or sample and tell us the equipment model and part name.