Underground LHD loader · 1999–2009 · 1 model
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Tamrock Toro LHD | Toro 151; Toro 6; Toro 7M; Toro 9; Toro 10; Toro 11; Toro 2500E; Toro 400; Toro 1250D; Toro 007 | 1999–2009 | 6 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Bucket | Bucket at the front of the loader | Toro 400 |
| 2 | Bucket Cutting Edge | Leading edge of the bucket | Toro 400 |
| 3 | Tyre | Wheel on the front frame | Toro 400 |
| Component |
|---|
| Lift Cylinder |
| Steering Cylinder |
| Transmission |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component | Location |
|---|---|---|
| 1 | Bucket | |
| 2 | Model-specific component | Front edge of the bucket |
| 3 | Tire | |
| Model-specific component | ||
| Model-specific component | ||
| Model-specific component |
The Toro LHD Underground LHD loader is also documented under these designations: Tamrock Toro LHD, Toro 151, Toro 6, Toro 7M, Toro 9, Toro 10, Toro 11, Toro 2500E, Toro 400, Toro 1250D, Toro 007.
The Toro LHD Underground LHD loader is listed under the Tamrock brand as: Underground LHD loader. Period: 1999–2009. Status: Historical model.
6 components are recorded, including: Bucket, Tire and more. The full list with locations is in the components table on this page.
Sandvik LH.
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry