1999–2009 · 1 model
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Tamrock Solo | Solo 05 126 LC10; Solo 5-5C; Solo 5-5P; Solo 5-5F; Solo 5-5V; Solo 7-7C; Solo 7-7F; Solo 7-7V; LP-126LC; Solo H606; Solo H608; Solo H808 | 1999–2009 | 11 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Rock Drill | Carriage at the rear end of the feed | Solo 05 126 LC10 |
| 2 | Drill Feed | Horizontal feed in front of the carrier | Solo 05 126 LC10 |
| 3 | Drill Boom | Between carrier and feed | Solo 05 126 LC10 |
| 4 | Rod Handler | Rod handler below the feed | Solo 05 126 LC10 |
| 5 | Tyre | Rear wheel of the carrier | Solo 05 126 LC10 |
| Component |
|---|
| Hydraulic Pump |
| Hydraulic Cylinder |
| Drill rod |
| Drill bit |
| Hydraulic control valve |
| Fuel Filter |
| Engine Oil Filter |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component |
|---|---|
| 1 | Model-specific component |
| 2 | Feed beam |
| 3 | Drill boom |
| 4 | Model-specific component |
| Hydraulic Pump | |
| Hydraulic cylinder | |
| Drill rod | |
| Drill bit | |
| Hydraulic control valve | |
| Model-specific component | |
| Model-specific component |
The Solo is also documented under these designations: Tamrock Solo, Solo 05 126 LC10, Solo 5-5C, Solo 5-5P, Solo 5-5F, Solo 5-5V, Solo 7-7C, Solo 7-7F, Solo 7-7V, LP-126LC, Solo H606, Solo H608, Solo H808.
The Solo is listed under the Tamrock brand. Period: 1999–2009. Status: Historical model.
11 components are recorded, including: Feed beam, Drill boom, Hydraulic Pump, Hydraulic cylinder, Drill rod, Drill bit, Hydraulic control valve and more. The full list with locations is in the components table on this page.
5C / 5P→DL310, 5F→DL320, 5V→DL330, 7C→DL410.
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry