2017 · 1 model
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| DRS RollSizer roll Crusher | DRS 660 x 1500 CenterSizer; DRS 800 x 1500 CenterSizer; DRS 660 x 3000 SideSizer; DRS 660 x 3700 SideSizer | 2017 | 4 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Crushing tooth / tooth ring | Teeth on the crushing-roll circumference | DRS 660 x 1500 CenterSizer;DRS 800 x 1500 CenterSizer |
| 2 | Breaker bar | Central breaker bar below the two rolls | DRS 660 x 1500 CenterSizer;DRS 800 x 1500 CenterSizer |
| 3 | Crushing roll | Twin rolls crushing inward at the center | DRS 660 x 1500 CenterSizer;DRS 800 x 1500 CenterSizer |
| Component |
|---|
| Crushing comb |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component | Location |
|---|---|---|
| 1 | Crushing tooth/tooth ring | Outer circumference of the crushing roll |
| 2 | Crushing beam | Beneath the two rolls of the primary CenterSizer |
| 3 | Crushing roll | Parallel roll unit inside the housing |
| Crushing comb plate | Crushing zone on the side of the SideSizer housing |
The DRS RollSizer is also documented under these designations: DRS RollSizer roll Crusher, DRS 660 x 1500 CenterSizer, DRS 800 x 1500 CenterSizer, DRS 660 x 3000 SideSizer, DRS 660 x 3700 SideSizer.
The DRS RollSizer is listed under the Polysius brand. Period: 2017. Status: Historical model.
4 components are recorded, including: Crushing tooth/tooth ring, Crushing comb plate, Crushing beam, Crushing roll. The full list with locations is in the components table on this page.
Model-specific components with their own page: Crushing tooth/tooth ring, Crushing comb plate, Crushing beam, Crushing roll (4 in total).
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry