2026-10-03 · 1 model
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Mountaineer II | 5025; 5030; 6520; 6530; 8020; 8030; 10020; 10030; Timed / Untimed | 2026-10-03 | 5 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Toothed roll segments | Tooth rows of the twin rotors | Mountaineer II OEM family section (dimensions not specified) |
| 2 | Gear coupling | Between the reducer and rotor | Mountaineer II OEM family section (dimensions not specified) |
| 3 | Reducer | Yellow drive module behind the motor | Mountaineer II OEM family section (dimensions not specified) |
| 4 | Timing gearbox | Synchronizing gearbox outside the twin rotors | Mountaineer II OEM family section (dimensions not specified) |
| 5 | Drive motor | Drive module at the front of the base | Mountaineer II OEM family section (dimensions not specified) |
| Component |
|---|
| Rotor Bearing |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component | Location |
|---|---|---|
| 1 | Model-specific component | |
| 2 | Gear coupling | |
| 3 | Reducer | |
| 4 | Interlinked gearbox | Synchronizing drive mechanism of the two rotors |
| Rotor Bearing |
The Pennsylvania Crusher Mountaineer II Sizers is also documented under these designations: Mountaineer II, 5025, 5030, 6520, 6530, 8020, 8030, 10020, 10030, Timed / Untimed.
The Pennsylvania Crusher Mountaineer II Sizers is listed under the Pennsylvania Crusher brand. Period: 2026-10-03. Status: Historical model.
5 components are recorded, including: Rotor Bearing, Gear coupling, Reducer, Interlinked gearbox and more. The full list with locations is in the components table on this page.
Model-specific components with their own page: Interlinked gearbox (1 in total).
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry