2026-10-03 · 5 models
Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Period | Components |
|---|---|---|
| KREBS gravelMAX 10x8 | 2026-10-03 | 5 |
| KREBS gravelMAX 12x10 | 2026-10-03 | 5 |
| KREBS gravelMAX 14x12 | 2026-10-03 | 5 |
| KREBS gravelMAX 6x4 | 2026-10-03 | 5 |
| KREBS gravelMAX 8x6 | 2026-10-03 | 5 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location |
|---|---|---|
| 1 | Impeller | Red impeller in the wet-end section |
| 2 | Wear ring | Suction side in front of the impeller eye |
| 3 | Pump casing | Outer wet-end casing |
| Component |
|---|
| Bearing |
| Pump shaft |
Models with the same components are grouped together; select a group to open its component table.
Models: KREBS gravelMAX 10x8, KREBS gravelMAX 12x10, KREBS gravelMAX 14x12, KREBS gravelMAX 6x4, KREBS gravelMAX 8x6
| No. | Component |
|---|---|
| 1 | Impeller |
| 2 | Wear ring |
| 3 | Pump casing |
| Bearing | |
| Pump shaft |
The gravelMAX covers 5 models: KREBS gravelMAX 10x8, KREBS gravelMAX 12x10, KREBS gravelMAX 14x12, KREBS gravelMAX 6x4, KREBS gravelMAX 8x6. Former and renamed designations are listed in the models table on this page.
The gravelMAX is also documented under these designations: KREBS gravelMAX 10x8, KREBS gravelMAX 12x10, KREBS gravelMAX 14x12, KREBS gravelMAX 6x4, KREBS gravelMAX 8x6.
The gravelMAX is listed under the KREBS Cyclones and Slurry Pumps brand. Period: 2026-10-03. Status: Historical model.
5 components are recorded, including: Impeller, Wear ring, Pump casing, Bearing, Pump shaft. The full list with locations is in the components table on this page.
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry