5 models
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Adjustable dam gate | Dam gate at the discharge end of the trough | 50-486;50-488;50-4810 |
| 2 | Mixing trough | Trough around the twin mixing shafts | 50-486;50-488;50-4810 |
| Component |
|---|
| Paddle tip |
| Mixing shaft |
| Timing gear |
| Drop-out bottom |
Models with the same components are grouped together; select a group to open its component table.
Models: 50-4810, 50-486, 50-488, 52 Plant, 52S Plant
| No. | Component | Location |
|---|---|---|
| 1 | Discharge baffle door | Discharge end of the agitation tank |
| Agitator paddle wear tip | Leading edge of the agitator shaft paddles | |
| Agitating shaft | Twin shafts inside the agitation tank | |
| Synchronizing gear | Dual-shaft drive end | |
| Openable floor plate | Access position at the bottom of the agitation tank |
The Pugmill Continuous Double shaft agitator covers 5 models: 50-4810, 50-486, 50-488, 52 Plant, 52S Plant. Former and renamed designations are listed in the models table on this page.
The Pugmill Continuous Double shaft agitator is also documented under these designations: 50-4810, 50-486, 50-488, 52 Plant, 52S Plant.
The Pugmill Continuous Double shaft agitator is listed under the Kolberg-Pioneer brand. Status: Historical model.
5 components are recorded, including: Agitator paddle wear tip, Agitating shaft, Synchronizing gear, Discharge baffle door, Openable floor plate. The full list with locations is in the components table on this page.
Model-specific components with their own page: Agitator paddle wear tip, Agitating shaft, Synchronizing gear, Discharge baffle door, Openable floor plate (5 in total).
Send us a drawing or sample and tell us the equipment model and part name.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Or contact us directly: +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to the customer technical requirements, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
We review mating surfaces and interface dimensions and assess material, heat treatment and manufacturing feasibility.
Material grades and heat-treatment processes are specified order by order, stated in the technical agreement and tracked through production.
Drawing confirmation, material and process control, production tracking, inspection and acceptance coordination.
We coordinate manufacturing, quality confirmation, packaging and delivery of complete finished parts in a workable, closed-loop supply process.
Provide the existing model, drawings, drawing, materials or operating conditions so we can identify the appropriate technical review and supply route.
Submit an Enquiry