FLS SAG Mill Series

Series and models support equipment identification; manufacture still requires confirmation against the full model, serial number, part number and drawing.

OEM Equipment Series Page

FLS · SAG Mill Series

Provide the full model, serial number, part number or drawing for technical confirmation.

Verified models in this series

Drawing-based spare-part route

Spare-part identification and technical confirmation

Provide the equipment series, full model, serial number, part or drawing number, installed position, dimensions, material and operating duty. Compatibility and manufacturing scope are confirmed from the submitted record.

Engineering answer

SAG mill wear parts: what must be known before manufacture?

A SAG-mill part is defined by the installed mill and the component interface, not by a generic part name. The same discipline applies to Metso, FLS, CITIC HIC and other installed equipment.

What should be sent with a SAG mill liner enquiry?

Provide the OEM/brand where known, mill series and full model, serial number, liner position, part or drawing number, current part photos, dimensions, material requirement, ore and operating duty.

Can a liner be made from a similar SAG mill?

Only after the drawing, interfaces, fixing pattern and operating duty have been reviewed. Similar mill dimensions or a shared product name do not establish an interchangeable part.

How is liner material selected?

Material review starts with wear location, ore characteristics, impact, abrasion, media and the observed failure mode. The selection is recorded against the submitted part information.

Send equipment and operating data for engineering review

Provide the OEM, model, drawing or part number, current material, processed material, failure photos and target life. We will review structure, material and manufacturing scope.

Send RFQ Data

Direct contact: +86 156 3797 3199
zzx@anranst.com

Manufacturing Services in China

From Technical Assessment to Finished-Part Delivery

ANRANST gives global customers one responsible channel for Chinese custom wear parts and industrial spares: not a general trading marketplace, but a closed engineering loop of drawing review, material specification, casting at certified foundries, in-factory inspection at critical stages and heat-by-heat documentation.

Drawing and Engineering Review

Equipment and part identification, drawing review, material selection and manufacturing-feasibility support.

Material and Heat-Treatment Specification

Material grades and heat-treatment processes are specified order by order, confirmed in the technical agreement and tracked through production.

Quality Control

Drawing confirmation, material and process checkpoints, production follow-up, inspection and acceptance coordination.

Finished-Part Delivery

Coordinated manufacturing, quality confirmation, packing and delivery of complete finished components.

Send the available model, drawing, part number, material or operating conditions. We will determine the appropriate technical and supply route.

Send Drawings · Engineering Review First