سلسلة المعدات
Metso Nordberg C Series الكسارات الفكية
METSO · Part التفاصيل
ألواح وسيطة
Intermediate Plate
حدّد أجزاء كسارات الفك Metso، وتحقق من الطرازات وأرقام الرسومات، وأكِّد المواد والعمليات، ثم قدّم استفسارك.
المعدات, Models and Part Numbers
An intermediate plate changes jaw crusher chamber geometry and nip angle for low feed volumes, smaller feed or slippery material. It reduces the feed opening and maximum setting and may increase crushing forces, so the machine and jaw-die configuration must be checked. Intermediate plates are distinct from adjustment shims and intermediate rods.
Applicable Models
Confirm the intermediate plate option for the equipment model and jaw-die configuration.
Part Type
Intermediate plate
Part identification
Metso equipment and part specifications
Intermediate plate identification for ordering
Provide the equipment model, jaw-die configuration and intermediate plate drawing or existing part number to confirm ordering requirements.
أرقام القطع هي مراجع تحديد لماكينات سلسلة C من Metso Nordberg. أكِّد اللوحة الاسمية للمعدات والرقم التسلسلي والرسم قبل الطلب.
المواد والعمليات
Confirm intermediate plate material, manufacturing process and installation requirements against the specific part drawing.
Carbon steel specification
The intermediate plate must meet chamber load, fit and wear requirements. Generic thin-shim carbon steel grades and thicknesses cannot replace its part specification.
Stainless steel options
Assess alternative materials for support loads, fit and wear; corrosion resistance alone is not a basis for substitution.
Dimensions and configurations
Check thickness, profile, hole positions and jaw dies as a matched configuration. After installation, confirm the feed opening, setting range and allowable operating conditions.
Wear and Replacement Criteria
Inspect intermediate plate contact faces, profile and fastening condition. Determine replacement according to the machine's maintenance specification.
Main failure modes
Inspect contact-face indentation, plastic deformation, edge wear and corrosion, and assess their effects on jaw-die support and chamber geometry.
Replacement Criteria
Address wear, deformation or corrosion affecting support, fit or chamber geometry according to the model-specific maintenance procedure.
Recommended Actions
Clean and inspect mating surfaces during replacement and record the intermediate plate and jaw-die configuration. Verify fasteners and the revised setting range against model requirements.
Information Needed for an Inquiry
المعدات model, such as C140; jaw-die configuration; intermediate plate part number or drawing; thickness and hole positions; material requirements; and quantity.