سلسلة المعدات
Metso Nordberg C Series الكسارات الفكية
METSO · Part التفاصيل
ألواح توجيه التغذية
Deflector Plate
حدّد أجزاء كسارات الفك Metso، وتحقق من الطرازات وأرقام الرسومات، وأكِّد المواد والعمليات، ثم قدّم استفسارك.
المعدات, Models and Part Numbers
The deflector plate at the jaw crusher inlet directs feed toward the chamber centre, reducing uneven loading and direct sidewall impact. Its installation and wear condition affect how effectively the crushing chamber is used.
Applicable Models
C80 وC96 وC100 وC106 وC110 وC120 وC125 وC130 وC140 وC150 وC200 وC3054
Part Type
Deflector plate
Part identification
Metso equipment and part specifications
Deflector plate part numbers
يرجى توفير اللوحة الاسمية للمعدات والطراز الكامل ورقم القطعة الحالي أو الرسم لتحديد القطعة المطلوبة.
المواد والعمليات
Review the following deflector plate material and process information when assessing specifications and alternatives.
Hardox Wear-Resistant Steel Plate
Hardox 400/450 and NM400/NM500 may be considered for deflector plates. Check each grade against thickness, impact conditions and the drawing; do not assume direct equivalence.
Manganese steel castings
Mn13Cr2 manganese steel may be considered for impact duties. Verify heat treatment, initial hardness and actual work-hardening response against the drawing and operating conditions.
Composite liners
Ceramic-rubber composite liners may be considered for suitable wear locations after assessment of impact, temperature, attachment and material compatibility. Evaluate life from site operating results.
Wear and Replacement Criteria
Use the following deflector plate wear patterns and replacement considerations during maintenance.
Main wear zones
The leading edge exposed to impact, the face over which material slides, and mounting-bolt heads. Deflector wear can cause uneven feed loading.
Replacement Criteria
Assess remaining thickness against model-specific maintenance limits. Stop and inspect if leading-edge wear changes material flow, or if there is wear-through or cracking.
Recommended Actions
Inspect deflector wear and installation angle regularly. Observe whether feed is distributed evenly across the crushing chamber.
Information Needed for an Inquiry
المعدات model, such as C125; part number or drawing; material requirements, such as Hardox 400, manganese steel or composite; thickness; and quantity.