What other names or designations is the Jeffrey Rader Mini-Mill known by?
The Jeffrey Rader Mini-Mill is also documented under these designations: Mini-Mill, 30ABE, 34ABE.
2012 · 1 model


Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Jeffrey Rader Mini-Mill | Mini-Mill; 30ABE; 34ABE | 2012 | 7 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Hammer | Hammers exposed by the opened housing | Mini-Mill;MME |
| 2 | Rotor disc | Discs between the rotor hammers | Mini-Mill;MME |
| 3 | Rotor shaft | Left-hand rotor shaft end | Mini-Mill;MME |
| 4 | Housing | Outer crushing-chamber housing | Mini-Mill;MME |
| 5 | Bearing housing | Left-hand shaft support | Mini-Mill;MME |
| Component |
|---|
| Hammer pin |
| Crushing plate |
| Screen bar |
| Housing liner |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component |
|---|---|
| 1 | Hammer head |
| 2 | Rotor disc |
| 3 | Rotor shaft |
| Hammer shaft | |
| Crushing plate | |
| Screen bar | |
| Housing liner |
The Jeffrey Rader Mini-Mill is also documented under these designations: Mini-Mill, 30ABE, 34ABE.
The Jeffrey Rader Mini-Mill is listed under the TerraSource Global brand. Period: 2012. Status: Historical model.
7 components are recorded, including: Hammer head, Hammer shaft, Rotor disc, Crushing plate, Screen bar, Housing liner, Rotor shaft. The full list with locations is in the components table on this page.
Envoyez-nous un plan ou un échantillon et indiquez le modèle d'équipement et le nom de la pièce.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Ou contactez-nous directement : +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to drawing, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
Veuillez fournir la marque de l’équipement, le modèle complet et le numéro de série, le nom de la pièce, sa référence ou le numéro du plan, l’indice de révision du plan, la quantité, les exigences relatives au matériau et les conditions de service. Si ces identifiants ne sont pas disponibles, envoyez des photographies et les dimensions principales.
Submit an Enquiry