What other names or designations is the Tamrock Quasar Face known by?
The Tamrock Quasar Face is also documented under these designations: Quasar 1F, Quasar NV.
1999–2009 · 1 model


Select a model to jump to its component table; former and renamed designations are listed under “Historical names / renamings”.
| Model | Historical names / renamings | Period | Components |
|---|---|---|---|
| Tamrock Quasar Face | Quasar 1F; Quasar NV | 1999–2009 | 8 |
The numbers on the diagram correspond one to one with the rows below.
| No. | Component | Location | Applies to |
|---|---|---|---|
| 1 | Rock Drill | Rock drill carriage at the rear of the feed | Quasar 1F |
| 2 | Drill Feed | Horizontal feed at the working end of the boom | Quasar 1F |
| 3 | Drill Boom | Between carrier and feed | Quasar 1F |
| 4 | Hydraulic Cylinder | Actuating cylinder on the inner side of the boom | Quasar 1F |
| 5 | Tyre | Rear wheel of the carrier | Quasar 1F |
| Component |
|---|
| Hydraulic Pump |
| Drill rod |
| Drill bit |
Models with the same components are grouped together; select a group to open its component table.
| No. | Component |
|---|---|
| 1 | Model-specific component |
| 2 | Feed beam |
| 3 | Drill boom |
| 4 | Hydraulic cylinder |
| 5 | Tire |
| Hydraulic Pump | |
| Drill rod | |
| Drill bit |
The Tamrock Quasar Face is also documented under these designations: Quasar 1F, Quasar NV.
The Tamrock Quasar Face is listed under the Tamrock brand. Period: 1999–2009. Status: Historical model.
8 components are recorded, including: Feed beam, Drill boom, Hydraulic Pump, Hydraulic cylinder, Drill rod, Drill bit, Tire and more. The full list with locations is in the components table on this page.
1F→DD210, NV→DD210-V.
Envoyez-nous un plan ou un échantillon et indiquez le modèle d'équipement et le nom de la pièce.
Provide the equipment model, drawing for engineering review and quotation. If service life or wear is a concern, describe the operating conditions as well.
Ou contactez-nous directement : +86 156 3797 3199
zzx@anranst.com
ANRANST provides customers worldwide with engineering assessment, production at certified foundries to drawing, quality control and finished-part delivery for custom wear parts and industrial spares, with scope to support other custom industrial parts.
Veuillez fournir la marque de l’équipement, le modèle complet et le numéro de série, le nom de la pièce, sa référence ou le numéro du plan, l’indice de révision du plan, la quantité, les exigences relatives au matériau et les conditions de service. Si ces identifiants ne sont pas disponibles, envoyez des photographies et les dimensions principales.
Submit an Enquiry