TowerMill: Wet-End and Nameplate Identification

Retain the NE or ETM prefix, leading zeros and L suffix where shown. Complete lineup on the cited manufacturer page: NE-008; NE-024; NE-024L; ETM-10; ETM-20; ETM-50; ETM-100; ETM-150; ETM-300; ETM-500; ETM-700; ETM-1000; ETM-1250; ETM-1500; ETM-1750; ETM-2000; ETM-2500.

OEM series guide

Identify the installed design before enquiry

EIRICH TowerMill is a vertical agitated media mill with a suspended double-helical screw. Replaceable screw-flight liners protect the agitator, while shell grid liners retain a protective material layer inside the chamber. Identify your parts: send nameplate and the installed screw and grid-liner arrangement.

TowerMill

Wet-end and wear-part identification

Retain the NE or ETM prefix, leading zeros and L suffix where shown. Complete lineup on the cited manufacturer page: NE-008; NE-024; NE-024L; ETM-10; ETM-20; ETM-50; ETM-100; ETM-150; ETM-300; ETM-500; ETM-700; ETM-1000; ETM-1250; ETM-1500; ETM-1750; ETM-2000; ETM-2500. source

  • Identify replaceable liners on the double-helical screw flights, including segment position and fixing details. [source]
  • Identify shell grid-liner geometry and the material-retaining grid arrangement. [source]
  • Record rubber-lined shell surfaces separately from screw-flight and shell-grid wear components. [source]
  • Include the installed screw, shell assembly and upper-drive interfaces in the identification record. [source]

Nameplate identification

Request clear mill and drive nameplates: manufacturer, complete mill model and suffix, serial/equipment number, year, rated power and speed where stated. Identify your parts / send nameplate.

screw-flight segment position; shell-grid geometry; rubber-lining arrangement; fixing pattern; assembly revision

Identify your parts / send nameplate

Identify your parts / send nameplate

Send the full nameplate photo, model designation, serial number and photographs of the installed wear parts. ANRANST quotes aftermarket wear parts after identification; no interchange numbers are published.

اطلب عرض سعر

أو تواصل معنا مباشرة: +86 156 3797 3199
zzx@anranst.com

خدمات التصنيع في الصين

من التقييم الفني إلى تسليم القطع الجاهزة

تقدّم ANRANST لعملائها حول العالم التقييم الهندسي والإنتاج في مسابك معتمدة وفق المتطلبات الفنية للعميل ومراقبة الجودة وتسليم القطع الجاهزة لقطع التآكل المخصّصة وقطع الغيار الصناعية، مع إمكانية دعم قطع صناعية مخصّصة أخرى.

يرجى تقديم العلامة التجارية للمعدة، والطراز الكامل والرقم التسلسلي، واسم القطعة، ورقم القطعة أو رقم الرسم، وإصدار الرسم، والكمية، ومتطلبات المادة وظروف التشغيل. إذا لم تتوفر بيانات التعريف، فأرسل صورًا والأبعاد الرئيسية.

أرسل استفساراً